Chassis

 

• Chassis material is free and to be no thicker than 3mm but must retain Mardave V12 wheelbase and track .

• All sharp edges should be smoothed down out on the chassis.

• Rear extension plates are allowed, but should be no wider than the chassis and be no thicker than 3mm. 

• Chassis MUST be parallel.  Winged Chassis are permitted.

 

Shells

 

• Shell are to be made from ABS

• Shells are to be cut to represent the full size counterpart.

​

Batteries

 

• Only 4 cell Sub C NiCads & ni-mh cells permitted.

• Matched or unmatched cells permitted.

• Max 5000Mah

• They must be covered in clear heat shrink or the manufacturers covering with identification clearly visible

• Battery bars must be no wider than the battery.

 

 

Speed Controllers

 

• Manual and Electronic Speedo's are permitted

• Electronic Speedo Maximum RRP is £35

 

Gears, Motor Pod & Axle

 

• 32dp pinion gears only. Pinions minimum 12 tooth, max 18 tooth. 

• Gear sleeves/clips are allowed on the Mardave gear arms.

• Standard Mardave or TIC axle can be used

• Ball races may only be used on the back axle.

• Pod Braces are permitted

​

Wishbones, Steering Arms & King Pins 

 

• Steering arms can be standard or may be modified to the ball and link type. 

• Wishbones are to be standard, either Mardave or TIC and must be hollow.

• No Ally Wishbones permitted

• No wishbone protectors or any other strengthening of wishbones.

• Front springs must be fitted.

• Only standard, hardened and stainless King pins allowed.

• No pipe to be fitted to kingpins. 

​

Motors

 

• Mardave G1 & G2.

• Grapner 500 standard.

• Johnson 540 with plastic endbell.

• HPI Saturn 27T. 

• Tamiya Mabuchi 540 Silver Can with black endbell.

• Hunter systems 27t.

• Ansmann clash 28t.

• Heat sinks can be fitted.

• Use of motor cleaning fluids and additives allowed.

​

Tyres

 

• Must be foam tyres.

• No tyre additives permitted. 

• Any after market wheel must be of the same diameter as per Mardave V12, 

• Kamtec, Contact Wheels, or TIC Bruno Wheels.

• Ball raced front wheels are not permitted.

​

Ride Height

​

• Ride Height is a Minimum of 3mm

​

Ballast and Weights

​

• Adding extra corner weights or ballast is not permitted.

​

Bumpers

​

• Bumpers must be fitted to the front and back of the chassis. the rear bumper can be a single rail, front must be a double.

​

Servo Savers

​

• Any type of servo saver permitted.

• A small piece of ABS is allowed behind the servo saver as a servo saver protector.